help-calc

08 Numbers and Units

Normal E/e’ Ratio: Echo Values Explained

Card 08-0337 · Updated · Standard formula, shown below

The calculator on this page is switched off while it is checked. The formula is below, and the worked example shows how to do the sum by hand.

This calculator estimates the normal range for the E/e’ ratio, a key echocardiographic measurement of left ventricular filling pressure. You enter the mitral inflow E-wave velocity (cm/s) and the e’ tissue Doppler velocity (cm/s) from an apical four-chamber view, and you get the E/e’ ratio with interpretive context. The E/e’ ratio is a dimensionless number that helps clinicians assess diastolic function and estimate left atrial pressure.

Formula

The E/e’ ratio is simply the ratio of two Doppler velocities measured during echocardiography:

E/e’ = E-wave velocity ÷ e’ velocity

  • E-wave (E): peak early diastolic mitral inflow velocity, measured in cm/s. This reflects the pressure gradient between the left atrium and left ventricle during early diastole.
  • e’ (e prime): peak early diastolic mitral annular velocity, measured in cm/s using tissue Doppler imaging. This reflects the rate at which the mitral annulus (the ring of tissue around the mitral valve) moves away from the apex during early diastole, which is a surrogate for left ventricular relaxation.

The ratio is unitless because both velocities are measured in the same units (cm/s). A higher ratio suggests higher left ventricular filling pressure, while a lower ratio suggests normal or low filling pressure.

Worked Example

Using the default values from the calculator:

  1. Mitral E-wave velocity = 70 cm/s
  2. Mitral e’ velocity = 8 cm/s
  3. E/e’ = 70 ÷ 8 = 8.75

The calculator displays 8.8 (rounded to one decimal place). An E/e’ of 8.8 falls in the intermediate range (8–14), meaning filling pressures are likely normal but not definitively so. The interpretation output shows “0” because the calculator computes the numeric ratio only; clinical interpretation requires the full echocardiographic context.

What the Numbers Mean

The E/e’ ratio is interpreted using well-established cutoffs from clinical guidelines, though exact thresholds vary slightly by guideline and patient population. Generally:

  • E/e’ ≤ 8: normal left ventricular filling pressure (mean left atrial pressure < 15 mmHg). This is reassuring in most patients.
  • E/e’ 9–13: intermediate or indeterminate zone. Filling pressures are likely normal but may be elevated in some conditions, especially if other diastolic parameters are abnormal.
  • E/e’ ≥ 14: elevated left ventricular filling pressure (mean left atrial pressure ≥ 15 mmHg). This suggests diastolic dysfunction with increased left atrial pressure.

These cutoffs apply primarily to patients with preserved left ventricular ejection fraction. In patients with reduced ejection fraction, a cutoff of ≥ 15 is often used for elevated filling pressure. The ratio is most reliable when the e’ velocity is measured at the septal mitral annulus; lateral annular measurements give slightly different normal values (lateral e’ is typically 1–2 cm/s higher than septal e’).

How to Measure E and e’

Both measurements come from a standard transthoracic echocardiogram, typically performed in the apical four-chamber view:

  1. E-wave measurement: Place the pulsed-wave Doppler sample volume at the tips of the mitral valve leaflets. The E-wave is the first, taller peak of the mitral inflow signal, occurring in early diastole. Measure its peak velocity.
  2. e’ measurement: Switch to tissue Doppler imaging mode. Place the sample volume on the septal (or lateral) mitral annulus. The e’ wave is the early diastolic peak of the annular motion signal, moving toward the apex (usually displayed as a positive deflection). Measure its peak velocity.

Both measurements should be averaged over 3–5 cardiac cycles if the patient is in sinus rhythm. In atrial fibrillation, average at least 5–10 beats. The e’ velocity is typically measured at both the septal and lateral annulus, and the average of the two is sometimes used, though many labs report septal e’ alone.

Common Pitfalls and Limitations

The E/e’ ratio is a powerful but imperfect tool. Several factors can make it unreliable:

  • Normal e’ with high E/e’: In patients with constrictive pericarditis, e’ may be normal or even increased despite elevated filling pressures, leading to a spuriously low E/e’.
  • Low e’ with normal filling: In patients with regional wall motion abnormalities (e.g., prior myocardial infarction), e’ at the affected segment may be reduced, giving a falsely high E/e’. This is why e’ should be measured at a normally functioning segment.
  • Heavy annular calcification: Calcification of the mitral annulus can reduce e’ velocity independent of relaxation, falsely elevating the ratio.
  • High heart rate: At very high heart rates, E and e’ waves may fuse with the A (atrial) waves, making accurate measurement difficult.
  • Mitral stenosis or prosthetic valves: The E-wave velocity is altered by valve pathology, so the ratio is not validated in these settings.

The ratio also does not distinguish between different grades of diastolic dysfunction (grade I, II, III). A patient with grade I dysfunction (impaired relaxation) may have a normal E/e’ because the E-wave is also reduced proportionally. Conversely, a patient with grade III (restrictive) dysfunction typically has a high E/e’.

Clinical Context and Other Diastolic Parameters

The E/e’ ratio is never interpreted in isolation. A complete diastolic assessment includes:

  • Left atrial volume index: Enlarged left atrium (> 34 mL/m²) suggests chronically elevated filling pressures.
  • Peak tricuspid regurgitation velocity: > 2.8 m/s indicates elevated pulmonary artery systolic pressure, which correlates with elevated left atrial pressure.
  • E/A ratio: The ratio of early to late (atrial) mitral inflow velocities. A reversed ratio (< 0.8) suggests impaired relaxation; a high ratio (> 2) suggests restrictive physiology.
  • Deceleration time: Short deceleration time (< 160 ms) of the E-wave suggests elevated filling pressure.
  • Valsalva maneuver: A change in E/A ratio of > 0.5 during Valsalva suggests pseudonormalization.

When E/e’ is intermediate (9–13), the other parameters become decisive. If left atrial volume is normal and tricuspid regurgitation velocity is normal, filling pressures are likely normal. If either is abnormal, elevated filling pressure is more likely.

Frequently Asked Questions

What is a normal E/e’ ratio? A normal E/e’ ratio is typically 8 or less when measured at the septal mitral annulus. Values between 9 and 13 are intermediate, and values of 14 or higher indicate elevated left ventricular filling pressure. These cutoffs apply to adults with preserved ejection fraction.

Why does my E/e’ ratio vary between reports? The ratio depends on which annular site is used (septal vs. lateral), the patient’s heart rate and blood pressure at the time of the exam, and the sonographer’s sample volume placement. Small variations in e’ measurement (±1 cm/s) can shift the ratio significantly, especially when e’ is low.

Can E/e’ be normal in heart failure? Yes. In heart failure with preserved ejection fraction, E/e’ may be normal at rest, especially in early disease. Exercise stress echocardiography can unmask abnormal filling pressures that are not evident at rest. Also, as noted, certain conditions like constrictive pericarditis can produce a false-normal ratio.

Is E/e’ the same as E/A ratio? No. The E/A ratio compares the early (E) and late (A) mitral inflow velocities, reflecting the pattern of filling. The E/e’ ratio compares the E-wave to the tissue Doppler e’ velocity, which estimates relaxation directly. Both are used together to grade diastolic dysfunction, but they measure different aspects of diastole.

What if my e’ velocity is very low? A low e’ velocity (typically < 7 cm/s at the septal annulus) indicates impaired myocardial relaxation, which is common in aging, hypertension, and left ventricular hypertrophy. If your E/e' is high because e' is low, it suggests that relaxation impairment is contributing to elevated filling pressures.

Does E/e’ predict prognosis? In multiple clinical studies, a higher E/e’ ratio (especially > 14–15) has been associated with worse cardiovascular outcomes, including higher rates of heart failure hospitalization and mortality. However, the ratio is one of many prognostic markers and should not be used alone to guide treatment decisions.

How to Use This Calculator

Enter the E-wave and e’ velocities exactly as reported on your echocardiogram report. The calculator will compute the ratio and round to one decimal place. The interpretation field is intentionally left as “0” because a single ratio cannot provide a definitive diagnosis. Use the result as a starting point for discussion with your cardiologist, who will integrate it with your full echocardiographic images, clinical history, and physical examination. The ratio is a screening and monitoring tool, not a standalone diagnostic test.

Related

Formula used
in e | Mitral E-wave velocity | cm/s | 70 | 20 | 200
in eprime | Mitral e' velocity | cm/s | 8 | 1 | 30
out ratio | E/e' ratio | - | e / eprime | 1
out grade | Interpretation | - | 0 + 0 * sqrt(e - eprime) | 0

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation, rounded as each result states. See how the calculators work or report an error.

More on this shelf

The whole Numbers and Units shelf →